Applications [ Return towards Craftmen and Worksites]

Your welding process is MIG/MAG - GMAW

Flame welding is performed with a welding torch and exclusively with an oxy-acetylen or oxy-crylen (available in some countries) flame.

Flame applications for cutting process use an oxy-fuel flame and straight oxygen as a cutting jet to separate the metal.

Your application involves hardfacing pieces as moulds. And you use manual powder guns with oxy-acetylene flame process.

Thermal coating, wire flame coating - anti-corrosion or wear-resistant coating.

Brazing processes are either manual or automatic.

Quenching is the process of modifying the surface properties of a piece, mainly to harden the surface.

Using nitrogen increases their lifetime and therefore decreases the recycling or treatment of this waste ...

This process consists in heating with a flame very quickly punctually or over a narrow area a sheet or a welded set of pieces. This operation allows to rectify the distortions on the thermally affected zone during the welding cycle.